You are here:

A comparison of golf swing kinematics among non-injured, rotator cuff injury-repaired, and rotator cuff injury-non-repaired golfers
THESIS

, University of Manitoba , Canada

University of Manitoba . Awarded

Abstract

The purpose of this proposed study was to develop a filming configuration that enabled acquisition of video film data to determine the 3D coordinates of the glenohumeral joint during a golf swing. The same filming configuration was then used to film golfers with either a current rotator cuff tear, or a recent surgically repaired rotator cuff. Video film data was collected on all three groups--10 non injured, 4 current rotator cuff tear, and 6 recent surgical repair. An ANOVA was completed to test for significant differences between the swing mechanics of each group of golfers. Post-hoc testing determined where the differences occurred.

The subjects for the study were low-handicap (handicap $\le$ 15) male golfers born in 1972 or earlier. The golfers were filmed using three video cameras which filmed six swings of each golfer using their driver. Once collected, the video film data was entered and analyzed using Peak5 Motion Analysis Software that configured a 27 point spatial model representing the segments of the golfer. (Abstract shortened by UMI.)

Citation

Gillespie, W.J. A comparison of golf swing kinematics among non-injured, rotator cuff injury-repaired, and rotator cuff injury-non-repaired golfers. Master's thesis, University of Manitoba. Retrieved April 19, 2019 from .

This record was imported from ProQuest on October 23, 2013. [Original Record]

Citation reproduced with permission of ProQuest LLC.

For copies of dissertations and theses: (800) 521-0600/(734) 761-4700 or https://dissexpress.umi.com

Keywords